Эмалированный Электрический скребок для краски 110 В/220 В 0 3-3 мм |

Wire diameter adjustment and related matters:1. When the enameled wire has different specifications, you can adjust the speed control potentiometer (hand-held) or adjust the speed regulator (fixed). The smaller the diameter of the wire, the slower the direction, the larger the diameter of the wire, the faster direction. If the film is not peeled off, increase the rotation speed until scraping. If the enameled wire is cut by a scraper during speed adjustment, the speed should be reduced until it meets the requirements. According to the above method, the most suitable speed is selected as the working speed of the corresponding wire diameter, and it can be considered that it has been adjusted.2. When the paint is scraped to the end of the enameled wire, the end should not be detached from the three blades immediately. The intersection of the cutting edge should wait for the cutter to stop rotating and then disengage the contact, so as to avoid the enameled wire suddenly detaching from the cutting edge and damaging the cutting edge during rotation.3. The shell uses voltage-resistant plastic material, which is safe and reliable.4. Before the enameled wire is scraped, it must be slightly straightened by hand to prevent the enameled wire from being misaligned with the center of the cutting edge.5. After using for a long time, you can unscrew the safety cover to remove the peeled paint film powder when the power is not available.4. Replace the work and repeat the above steps.3. Release the power button switch (hand-held) or relax the governor (fixed).2. Move the enameled wire in the opposite direction of the axis until the end of the enameled wire, the paint film can be scraped off.1. Put the enameled wire head to be scraped into the center of the knife holder, press the power start switch (hand-held) or the pedal governor (fixed), and the motor will rotate.Operation method：2. The fixed electric paint scraper is composed of two parts: electric power components (single-phase and series-excited motor), paint scraper and speed governor.1. The hand-held electric paint scraper is composed of an electronic stepless regulator, a single-phase series-excited motor and a paint scraper blade. It has the remarkable characteristics of fast paint scraping speed, high efficiency, simple operation, easy installation and stable quality, low failure rate, high production efficiency and novel design.Structure and composition：The new generation of DF-8 enameled wire electric paint scraper uses electric paint scraping technology, which can easily and quickly scrape the insulation paint film on the surface of various enameled wires without damaging the substrate. Its performance is better than similar electric paint scrapers and traditional manual knife. Scraping, grinding wheel, sandpaper screeding, chemical corrosion, etc. not only greatly improve the welding efficiency of wires, but also significantly improve the welding quality. It is ideal for coil manufacturing and maintenance industries such as motors, electrical appliances, meters, transformers, electronics, household appliances and power tools Paint scraperUse: