Бесплатная доставка цифровой МОП-транзистор Chilun V2 стабильная версия для AIRSOFT BB и

Бесплатная доставка цифровой МОП-транзистор Chilun V2 стабильная версия для AIRSOFT BB и

We can use electronic safety switch without installing block-thrust rod structure, which will use program power off to completely replace safety structure. The safety gear can also be set as a shooting gear, on the rifle, three functional gears can be achieved at the same time: single shot, double-stroke single-shot, and continuous shooting. The independent functions of the three gears can be quickly set， just in a few seconds, it is much more convenient to use.

The gear detection and trigger switch are nowlong-life micro-signal switches, which avoids the influence of gear grease pollution and ultraviolet interference on the fire control operation. The installation is simpler, and it is more friendly to ordinary users to install and debug. It is also more convenient to replace and maintain in the future, you only need an electric soldering iron to replace it yourself.

The adjustable braking force program is compatible with different quality motors, which can effectively improve the heating situationof low- and medium-torque motors. Of course, we still recommend using high-quality motors, which will get better performance and experience.

Provides up to 10 gears of preload travel options for the ladder, different gearbox can be adjusted to a suitable preload position, and low RPS gearbox can also achieve faster trigger firing response. Theoretically, by appropriate setting,the 15rps gearbox trigger response time can be shortened from about 70ms to about 15ms-30ms,get a firing delay close to 30+RPS without modifying the gearbox configuration.It not only retains the mild and friendly RPS that complies with the regulations of the field, but also obtains a high-performance firing response, and also reduces the heat of the motor.

For thehigh RPS gearbox, it is also possible to obtain the RPS that meets the requirements of different fieldsthrough the RPS electronic speed limit function, and this function will not affect the service life of the ETU.

Added voltage protection for 9.6V battery,now with settings,you canprevent the battery(7.4V, 9.6V and 11.1V)from being damaged by over-discharge. It supports the magazine feeding of the gel ball gearbox, and the pre-feeding function is added. The circuits of pre-feedingand voltage protection are independent, if the hardware is damaged, the program can be used to turn off these functions, and only the functions are completely shielded, it won’taffect regular shooting,which will reduce the repair rate, the pre-supply module supports a maximum current of 15A, and can support modification ofthe motor withextremely high speed.

Double-layer motherboard structure designseparate the trigger switch from the main circuit board, more scientific trigger limit structure,it completely solves the situation of the previous three-legmicro-switch beingcrooked and interrupted,and more convenient for DIY modification,simple modification of the triggercan achievemicro-travel firing.