Door access control short range rfid reader black white 125khz/13.56mhz pin code | Безопасность и защита

Door access control short range rfid reader black white 125khz/13.56mhz pin code | Безопасность и защита

Door access control short range rfid reader black white 125khz/13.56mhz pin code reader                                 

Specification:

Frequency: 125khz or 13.56mhz

Interface: wiegand 26 bits/34 bits

Card Type: ID/IC,NFC

Response Speed: Less than 0.2 second

Proximity Time Distance: Less than 0.5 seconds

Reading range: 5-10cmcm

Dimension: 86*86*18(mm)

Input Voltage: DC 9V-16V Working Voltage. Standard 12V, 70mA Working Current

Communication distance: Less than 100M

Features:

Built-in Antenna

Built-in LED (Double Color LED)

Built-in Loud Speaker (Buzzer)

Real Time Data Transfer

Audiovisual indication: When a registered card is presented to the reader, the LED flashes green and the beep sounds.

Can be open door by card only, keypad only or both card and keypad.

Note:

This is rfid card reader, don’t work alone, should work together with TCP/IP controller.

There are two color optional, we default send black color reader when you order, unless you had leave us message when order and advise us you need is white color reader.

Installation：

Using “+”type screw driver to loosen the screw between the panel and motherboard. And then embed the motherboard to the side wall with the plastic plug and screws.

Wire Connection：

WG26/34

Red： DC 9V-16V

Black：GND

Green：D0

White：D1

Notice！

1. Confirm the electric voltage (DC12V) and differentiate positive anode and cathode of power supply

2. When external Power is used, make sure sharing the power with Controller Box or using the same GND

3. The wire connects reader to controller, advise use 8 cores stranded twisted pair cable(among them, three strands are spare, if no need reader show illegal card s by sound and light, LED wire can not be used, data wire  Data1 Data0 are twisted pair would be better, we suggest sectional area are 0.22 square millimeter at least. The length should not exceed 100meters.

shielded wire connect to GND o