MILIVIXAY Pack of 2 Plastic Candle Molds for Making Pillar/Cylinder/Hexagon/Sprial Shaped Supplies Crafts |

MILIVIXAY Pack of 2 Plastic Candle Molds for Candle Making Pillar/Cylinder/Hexagon/Sprial Shaped Candle Making Supplies Crafts Specific:
- Good quality and easy to use and clean
- Plastic is heat resistant allowing for the safe burning of your candles
- Clear plastic allows for eye-catching, decorative colored candles
- It is a useful mould and tool for handmade soap and candle making
- Material: Plastic
Size:As Picture Show
Package included:2Pc Plastic Candle Mold(Only Mold, Not Included Candle)

Tips For Candle Making:
1. The surface can be porous due to low pouring temperature (below 140 ° F degrees), or because of the poor wax quality. Make sure to follow the recommended wax temperature before pouring.
2. The gloss on the surface may not be formed because of the higher pouring temperature than the recommended one. The higher the casting temperature, the glossier the surface of the finished candle is. Do not exceed the fill in temperatures of over 167° F degrees as this may cause leakage of the candle mass and difficulty in pulling out the candle from the mold.
3. It is normal if a well is formed after the product is finished. Candle mass expands when heated and decreases during solidification, so after its melting and gradual cooling, there is a well that is formed in the center of the candle.
4. The candle is removed from the mold with difficulty sometimes. It happens if the wax is heated to high temperatures, when there is an increase in the grip. The higher the temperature, the more cohesion is created and therefore it is more difficult to get the finished candle out of the mold. To avoid difficulties in removing, the mold needs to be lubricated before pouring and the temperature should not exceed 167° F degrees.