220V PIR Motion Sensor switch 50HZ Infrared Human Body Indction Detector ON/Off Control LED lamp lighting accessories | Освещение

220V PIR Motion Sensor switch 50HZ Infrared Human Body Indction Detector ON/Off Control LED lamp lighting accessories | Освещение

Description:

Suitable for filaments, energy-saving lamps

This lamp is equipped with a body sensor inside. If people come. Lin turns; if people leave, the lights will turn off

Inner body auto-sensing device uses infrared heat release device to automatically capture -frequency signals and power automatically

When people leave, the light will automatically extinguish, convenient energy-saving

The interior of the cab is set with the brightness of the vehicle circuit detection environment. Only when the ambient brightness is lower than the set , the sensor will receive the sensing signal and turn off the power. This is energy saving

1. Induction: PIR detection mode + light control

Voltage 2. Rated: 220V 50HZ

3. Output Mode: SCR

4. Load power: incandescent light ≤ 100W

Lights ≤30W

LED≤18W

6. Sensing distance: 3-6 meters (high temperature will affect the sensor switch)

7. Sensing angle: 110°

8. Sensitivity to Light: Darkness

Specifications:

Suitable for filaments, energy-saving lamps

This lamp is equipped with a body sensor inside. If people come. Lin turns; if people leave, the lights will turn off

Inner body auto-sensing device uses infrared heat release device to automatically capture -frequency signals and power automatically

When people leave, the light will automatically extinguish, convenient energy-saving

The interior of the cab is set with the brightness of the vehicle circuit detection environment. Only when the ambient brightness is lower than the set , the sensor will receive the sensing signal and turn off the power. This is energy saving

Package Included:

1*Inductive switch

Notes:

caveat:

1. During installation, disconnect power to ensure safety

2. Does not apply to suppress current or voltage

3. Do not install it near water

4. The detection distance will change according to the room temperature difference. In summer, the detection distance is very short (significantly close to the human body temperature); in winter, the detection distance is very large

5. Do not install below -20 degrees Celsius or above 60 degrees Celsius

6. Do not expose to sunlight

7. Do not install it in a place with moving objects

8. The first power, there will be a one-minute start; during this period, the device will shine, this is a normal phenomenon

9. In coastal areas, the flow activates thermal sensors due to ocean currents. If the filament is very hot, keep it away from the sensor (at least 1 meter)